Create a Launchpad

Step 1: Verify Token

1. Connect your wallet. 2. From the homepage, click on "Launchpads" "Create launchpad" or you can go to https://solstorm.com/launchpads/create 3. Select your preferred option and click on “Next Step”.

  1. Input your token address if you already have one, or create a new token for the Launchpad.

  2. Select currency

  3. Select a fee option.

  4. Select listing option (auto listing: liquidity will be added automatically after Finalize, manual listing: you have to add liquidity manually).

  5. After selecting, you can review again and click on “Next Step”.

Step 2: DeFi Launchpad Info

After verifying your token, you need to enter the Launchpad information that you want to raise. Here are some following important parameters:

1. You must use positive numbers.

2. Presale rate means shows how many tokens they will receive during the presale stage.

3. Choose listing router.

4. SoftСap must be greater than or equal to 25% of the HardCap.

5. Liquidity (%): Enter the percentage of raised funds that should be allocated to liquidity on router. Minimum value is 51%, maximum value is 100%.

6. Listing rate is the initial rate of the liquidity pool (1 SOL = x tokens). This rate is usually lower than the presale rate to allow a higher listing price on router.

7. Start time must be before the end time.

You can check the total tokens needed to create the presale pool (shown above the Back/Next buttons).

And you can use SOLSTORM Calculator to make a good tokenomic for your project.

Step 3: Add Additional Info

There are some notes for this step:

1. Logo URL and website are required fields, cannot be blank. You can’t complete this step without those.

2. Logo URL must end with a supported image extension: png, jpg, jpeg or gif.

For example: SOLSTORM.png

3. Click "Next Step" after done inputting.

Step 4: Review your information.

This is the final step. You can review all the information one last time before submitting, after you have made sure that everything is perfect, or you can go back to previous step to make any changes.

Click “Pay” as payment for lock, add your Email for notifications and "Complete setup".

Last updated